Tail Tidy Install Instructions

Thankyou for the purchase of your Solid Render Indian FTR Tail Tidy Kit! We hope you are happy with your purchase and if you have any issues, please contact us directly at SolidRenderL@gmail.com

Prep: If you got integrated lighting remove the lights from the tidy kit if pre-installed. Use a 7/16" drill bit, or a pocket knife, and wallow out the bottom 2 holes on your license plate, or wide enough to pass the blinker threads through. Once completed, line up the license plate with the lighting holes and reinstall lights by running the wire through the license plate and then through the tidy kit. Fasten lights with accompanying nut on the back side.

Step 1: Unbolt seat and unplug the 3 connectors for the license plate illumination and left/right blinkers.

Step 2: Remove OEM rear license plate/lighting assembly and remove the plastic fasteners securing the harness to the assembly.

Step 3: Bolt the new tail tidy kit into the 2 bolt holes located on the sub frame directly under the passenger seat and above the rear wheel.

Step 4: Snake the OEM tail light assembly harness, starting in between the fuel tank and the sub frame above the chain, up through until the end reaches under the seat where the OEM connectors are. This can be made easier by removing the bolts that secure the fuel tank. These bolts are located under the seat next to the OEM tail light assembly connectors. Doing this will allow you to slightly move the fuel tank up giving more clearance to snake the harness through.

Step 4: Snake the new tail tidy blinker/illumination connectors and wires under the rear of the fuel tank and under the seat.

Step 5: Connect 4-1 splitter harness to illumination lights, and then 4-1 splitter harness connector to OEM harness connector.

Step 6: Connect left and right blinkers to OEM connectors.

Step 7: Test blinkers and illumination

Step 8: Tuck wires where there will be no interference with the seat bracket and install seat.